Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Installing Transaction Plug-In

  1. Launch 3VR System Manager.

  2. In the Configure panel, click the plus sign beside the appliance name.

  3. Right-click the Plug-ins folder and select Add Plug-in.

  4. In the resulting Confirm dialog box, click Install to proceed.

  5. Navigate to the folder containing the plug-in file (Plugins.TellerTCPTransaction-Release-1.0.0.xxxxx-7.0) and click to highlight the file.

  6. Click OK. The plug-in will now begin installing.

  7. When the plug-in is installed, it will appear below Plug-ins in System Manager.

Configure Transaction Plug-In

Binding Camera to Plug-In

  1. Select the Teller ATM Transaction plug-in.

  2. Click the Bound Cameras field then click the ... button.

  3. In the Bind Plug-in to Cameras dialog box, click the check box beside each camera that should be associated with teller or ATM transactions.

  4. Click OK to save your changes and return to the Configure panel.

A pop-up will be displayed notifying you that the 3VR system software must be restarted after making changes. Click OK to close the pop-up message and acknowledge the warning. You will restart software as the last configuration step.

Configuring Per-Camera Settings

  1. After binding cameras to the plug-in (step 2.1), links will appear under Bound Cameras for each camera.

  2. Click a link (for example Edit “1. ATM 89B Camera”) to edit the settings for that camera.

  3. Type the ATM or Teller ID in the ATM/Teller ID box.

  4. Type the IP address of the ATM or Teller Workstation in the IP Address box.

  5. If desired, you may enter a name for the transaction source in the Computer Name box. This text will appear on event cards in 3VR OpCenter.

  6. Click OK to save your changes and return to the Configure panel.

  7. Repeat steps 2-4 for any remaining cameras bound to the Teller ATM Transaction plug-in.

If multiple ATMs are to be associated with a single camera, the IP Address and ATM/Teller ID fields should contain the IP addresses and IDs of all of the ATMs, separated by a comma with no spaces. The values for each ATM should be placed in the same order.

For example, if ATM 1234A (IP address 10.100.2.1) and ATM 5678B (IP address 10.100.2.3) are both to be assigned to camera 1 in the plug-in configuration, the ATM ID for camera 1 should be set to “1234A,5678B” and the ATM IP Address should be set to “10.100.2.1,10.100.2.3”.

  • No labels