Disable the Port, Xbox, Controller in DIGI*TRAC Configuration
Check the address number inside the Xxbox and controller on Velocity, and verify they are the same
Power down the controller
Set the address on the controller to the address number set inside Velocity
Set SW2, switches 1 and 4 to on
Power the controller on.
Wait for P1 SNIB light to toggle green and amber (could be green and red)
Open port properties > check reset encryption > check enable this port > press OK
Enable the xbox, then the controller
Verify communication is established between Velocity and controller by seeing controller event dump in event buffer.
Turn off switch 1 on SW2 once communication is confirmed.
See below for a Troubleshooting Flowchart