Disable Reporting

This page is intended to be used as suggestions for system use. It is in no way a requirement to follow these guidelines.

State Change Reporting notifies the user of door status in Event/Alarm Viewer. The user can choose to be notified of Door Contact status change, RQE status, Door Tamper status or Line Fault. User can also choose to be notified if these conditions are masked.

To disable reporting on door state change or mask state change on a single door, use the following steps:

  • Under the Controller, open the Door Properties

  • Select Input, and then select State Change Reporting

  • Check Disable State Change Reporting When Masked

To disable reporting on door state change or mask state change on a whole controller, use the following steps:

  • Open Controller Properties

  • Select Reporting, check Relay state changes to disable reporting of this condition

Â