...

Axis Network Door Controller (A1001)

...

1. Connect peripheral devices to the Axis PACS Device.

2. Enter the IP address of the Axis PACS Device in a web browser in order to launch the AXIS Entry Manager.

3. Select the “Hardware Configuration” “Hardware Configuration” link.

   Image RemovedImage Added

4. Start New Hardware Configuration.

   Image RemovedImage Added

5. Enter the number of connected doors as well as the names to use. Pay close attention to the name entered here as it will be necessary during the 3VR plug-in installation.

   Image RemovedImage Added

6. Configure the doors/locks.

   Image RemovedImage Added

7. Enter the reader information and click “Finish”“Finish”.

   Image RemovedImage Added

8. Open System Manager, expand the appliance name, right click the “Plug-ins” folder and select “Add Plug-in…”.

   Image RemovedImage Added

9. Choose the AxisPACS.3pg plug-in file.

   Image RemovedImage Added

10. Once the plug-in has installed successfully, left-click it and select “Edit Settings…” “Edit Settings…” in the top-right corner.

    Image RemovedImage Added

11. Enter the IP address, username, and password of the device.

12. Click the Access Management link below Edit Settings.

13. Select the Doors tab in order to add identification types to the door readers.

    Image RemovedImage Added

14. In the Add Identification Type window, select which credentials are needed for this particular reader and assign any number of schedules to that identification type. More than one ID type can be added to each reader.

    Image RemovedImage Added

15. Navigate to the Users tab and add any number of users. The Retrieve button will retrieve the Card Numbers for the last card that was swiped on the selected reader.

    Image RemovedImage Added

16. Navigate to the Groups tab in order to configure access groups.

    Image RemovedImage Added

    • The Start and End dates list the start and end of when this group is valid

    • The Members box lists which Users are members of this group

    • The Doors box lists which Doors this Group has access to

    • The Schedules box lists specific time-spans for which this Group is valid.

17. If desired, you can navigate to the Schedules tab in order to create customer schedules. This step is optional.

    • Additional Schedules are used to add access times

    • Subtraction Schedules are used to subtract access times

    • Add any number of Schedule Items to your schedule.

      Image RemovedImage Added

18. Click the button next to the “Bound Cameras” “Bound Cameras” property in order to bind cameras to the plug-in.

    Image Added

19. Bind some cameras to the plug-in. These will most likely be cameras pointing at the doors which the device is controlling.

    Image Added

20. Once channels have been bound, edit the individual channel’s plug-in settings.

    Image Added

21. Enter the name of the door that this camera will be watching.
    

    Image Added

22. Restart the plug-in.

    Image Added

23. Axis PACS Device events can now be monitored in the OpCenter under the “Monitor” tab. Events can also be searched for in the “Search” Tab.

Configuring a System of PACS Devices

1. In the PACS device’s web UI, navigate to the Setup tab and click Manage Network Door Controllers in System.

   Image Added

2. Add any other PACS devices to the system either by IP/ MAC address or from a list.

   Image Added

3. Once the system is configured, the Axis PACS plug-in can connect to any PACS device within the system and it will receive access control events from all PACS devices in that system.