...
| Table of Content Zone | ||||
|---|---|---|---|---|
|
Axis Network Door Controller (A1001)
...
Connect peripheral devices to the Axis PACS Device.
Enter the IP address of the Axis PACS Device in a web browser in order to launch the AXIS Entry Manager.
Select the “Hardware Configuration” link.
Start New Hardware Configuration.
Enter the number of connected doors as well as the names to use. Pay close attention to the name entered here as it will be necessary during the 3VR plug-in installation.
Configure the doors/locks.
Enter the reader information and click “Finish”.
Open System Manager, expand the appliance name, right click the “Plug-ins” folder and select “Add Plug-in…”.
Choose the AxisPACS.3pg plug-in file.
Once the plug-in has installed successfully, left-click it and select “Edit Settings…” in the top-right corner.
Enter the IP address, username, and password of the device.
Click the Access Management link below Edit Settings.
Select the Doors tab in order to add identification types to the door readers.
In the Add Identification Type window, select which credentials are needed for this particular reader and assign any number of schedules to that identification type. More than one ID type can be added to each reader.
Navigate to the Users tab and add any number of users. The Retrieve button will retrieve the Card Numbers for the last card that was swiped on the selected reader.
Navigate to the Groups tab in order to configure access groups.
The Start and End dates list the start and end of when this group is valid
The Members box lists which Users are members of this group
The Doors box lists which Doors this Group has access to
The Schedules box lists specific time-spans for which this Group is valid.
If desired, you can navigate to the Schedules tab in order to create customer schedules. This step is optional.
Additional Schedules are used to add access times
Subtraction Schedules are used to subtract access times
Add any number of Schedule Items to your schedule.
Click the button next to the “Bound Cameras” property in order to bind cameras to the plug-in.
Bind some cameras to the plug-in. These will most likely be cameras pointing at the doors which the device is controlling.